Calorimetric Measurements of a High-Power RF Signal

Development of a high-power RF signal meter based on the method of calorimetric measurements, which in some cases is the only possible one is presented. The device is as a system of elements exchanging either energy or information, the operation and interconnection of which ensures the stability of its functioning. The main elements of the device are: a coordinated load and a two-circuit water-air cooling system that convert RF energy first into thermal electrical energy, and then into internal energy of the coolant (working fluid). The measurement and control system provides information display on the monitor and generation of internal control signals. The work focuses on the process of converting electromagnetic energy into internal energy of the coolant, since the matched RF load is integrated into the cooling system and requires special design and technological solutions to ensure efficient operation. A cooling and measurement system has been designed to test the developed RF absorber with a power of up to 5 kW. The parameters of the cooling system were determined based on minimizing the time to achieve thermal equilibrium (time to establish readings) and the set parameters (input temperature no more than 35 °С, temperature difference no more than 40 °С). Based on calculations of the electrodynamic model constructed by the partial domain method, the geometric dimensions were determined at which the voltage standing wave ratio of the load in the operating frequency range (from DC to 1300 MHz) will be the smallest. The article presents the results of designing a high-frequency wattmeter cooled by a liquid (water), examines the thermophysical processes occurring in it and the influence of the presence of a coolant in the cooling circuit.

1. Popov IA, Makhyanov HM, Gureev VM. Physical foundations and industrial application of heat transfer intensification: Heat transfer intensifi monograph. Kazan: Center for Innovative Technologies, 2009. 560 p.

2. Vlasova KV. Block diagram of a measuring stand for measuring electrical power by the calorimetric method. Issues of sustainable development of society. 2022;(4):987-991.

3. Killinger A, Gantenbein G, Illy S, Ruess T, Weggen J, Martinez-Garcia V. Plasma Spraying of a Microwave Absorber Coating for an RF Dummy Load. Coatings 2021;11(7):801. DOI: 10.3390/COATINGS11070801

4. Jiang HC. [et al.] Microwave power thin film resistors for high frequency and high power load applications. Applied Physics Letters.2010;97(17):173504-3. DOI: 10.1063/1.3507883

5. Ryu SK. [et al.] High-voltage ultra wideband coaxial load with distributed ceramic-carbon-rod resistor. IEEE Transactions on Electromagnetic Compatibility. 2012;54(3):681-684. DOI: 10.1109/TEMC.2012.2197001

6. Kirillov PL. Heat transfer in a turbulent flow. Part 2. Distribution of velocity and temperature. Atomic energy. 2017;122(4):192-203.

7. Vlasova SS, Prosviryakov EYu. Two-dimensional convection of an incompressible viscous fluid with the heat exchange on the free border, Vestn. Samar. Gos.Tekhn. Univ., Ser. Fiz.-Mat. Nauki [J. Samara StateTech. Univ., Ser. Phys. Math. Sci.]. 2016;20(3):567-577. DOI: 10.14498/vsgtu1483

8. Andreopoulos Ya. Correlation of vorticity and velocity in compressible flows: experimental study of helicity density in turbulent flow and vortices. Electrochemistry. 2008;44(4):422-428.

9. Salnikov MV. [et al.]. Swirl flow in a cylindrical container: lattice Boltzmann equations and Navier— Stokes equations. Thermophysics and aeromechanics. 2022;29(4):531-541. DOI: 10.1134/S0869864322040060

10. Manzhai VN, Konovalov KB, Kazaryan MA. Behavioral model of macromolecules in a turbulent flow and its analytical consequences. Brief reports on physics of the FIAN. 2017;44(12):347-349. DOI: 10.3103/S1068335617120016

11. Lobanov IE. Mathematical modeling of intensified heat transfer in pipes with turbulators in turbulent flow at high Reynolds numbers. Bulletin of the Ufa State Aviation Technical University. 2017;21(4(78)):69-77.

12. Ilyin VI. [et al.]. Measurements of the generated microwave power and thermal loads during testing of ITER gyrotron prototypes on a test bench. Issues of atomic science and technology. Series: Thermonuclear fusion. 2011;(2):53-57.

13. Budaragin R, Zykov YuA, Radionov AA. The study of the relative convergence of the solution when calculating stepwise irregularities in a transmission line by the partial domain method using the energy orthogonality condition. Antennas. 2021;270(2):35-38. DOI: 10.18127/j03209601-202102-05

14. ITU-R recommendations of the P. 527-4 series, Electrical characteristics of the Earth's surface. Series R. Propagation of radio waves, 2017, No. 06.